Meyer M1D Ultra Compact Loudspeaker


Description

The Meyer Sound M1D ultra-compact curvilinear array loudspeaker brings the singular advantages of self-powered line arrays to sound reinforcement applications in small and mid-sized venues. The exceptionally compact enclosure enables sound designers to achieve high output, precise pattern control with very low distortion from a lightweight and unobtrusive system. The M1D provides a substantial peak SPL of 125 dB at 1 meter with an operating frequency range of 60 Hz - 18 kHz and is designed specifically for implementing vertical curvilinear arrays of up to 16 cabinets having 0- to 8-degree splay between adjacent units. This design affords the flexibility to tailor vertical coverage by varying the number and splay of cabinets in the array while maintaining a consistent 100° horizontal coverage.


Technical Specification

ACOUSTICAL

  • Operating Frequency Range: 60 Hz - 18 kHz
  • Frequency Response: 75 Hz - 15 kHz ±4 dB
  • Phase Response: 800 Hz - 12 kHz ±45°
  • Maximum Peak SPL: 125 dB
  • Dynamic Range: >110 dB

 

COVERAGE

  • Horizontal Coverage: 100°
  • Vertical Coverage: Varies, depending on array length and configuration; for a single loudspeaker, 10° minimum

 

CROSSOVER

  • 1900 Hz

 

TRANSDUCERS

  • Low Frequency:
  • Two 5" cone drivers
  • Nominal impedance: 8 Ω
  • Voice coil size: 1"
  • Power-handling capability: 200 W (AES)

 

High Frequency

  • Three 0.75" metal dome tweeters with neodymium magnets
  • Nominal impedance: 8 Ω
  • Voice coil size: 20 mm
  • Power-handling capability: 15 W (AES)

 

AUDIO INPUT

  • Type: Differential, electronically balance
  • Maximum Common Mode Range: ±15 V DC, clamped to earth for voltage transient pro
  • Connectors: Female XLR input with male XLR loop output
  • Input Impedance: 10 kΩ differential between pins 2 and 3

 

WIRING

  • Pin 1: Chassis/earth through 220 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
  • Pin 2: Signal +
  • Pin 3: Signal –
  • Case: Earth ground and chassis
  • AMPLIFIER
  • Type: Two-channel complementary MOSFET output stages (class AB/bridged)
  • Output Power: 500 W total
  • THD, IM, TIM: <.02%
  • Load Capacity: 4 Ω low channel, 2 Ω high channel
  • Cooling: Forced air cooling over amplifier heatsink

 

AC POWER

  • Connectors:PowerCon with looping output

 

PHYSICAL

  • Rigging: QuickFly® MRF-1D rigging frame
  • Dimensions: 585 mm x 181 mm x 216 mm
  • Weight:?14.06?kg
Product added!